Alfatronix PowerVerter PV3s 24Vdc - 12Vdc Voltage Converter

Further details of Alfatronix PowerVerter PV3s 24Vdc - 12Vdc Voltage Converter

• These products offer a convenient way to operate mass produced 12Vdc equipment such as cell phones, in car entertainment, professional communications, telematics equipment, refridgerators, televisions etc. from the 24Vdc mobile electrical systems found on diesel engined vehicles and vessels.
•from 3A to 50A in isolated or common earth configurations. They have been optimised for high volume 24Vdc to 12Vdc applications such as on heavy goods vehicles, coaches, buses, forestry and agricultural vehicles, as well as commercial and leisure marine vehicles.
• These units are IP53, so there are no ventilation holes to permit stray objects, dust or water droplets to enter the case, there are no external fuses to be tampered with. Fuses will only blow if there is a fault so there is no need to make them accessible.
• Many PowerVerters and DD Series products can be configured with alternative output voltages etc. for specialist applications. Please call our sales team to discuss your requirements
• All the units consume an off load current of less than 15mA, which is probably less than the self discharge current of the vehicle’s battery. In most cases this can be ignored, speeding the installation by removing the need to fit a remote switch.
• All products fit onto a ‘Click ‘n’ Fit mounting clip which is fixed in three points allowing it to be mounted on uneven surfaces. It is easy to fit the clip into awkward places and then simply click the unit into position.
• A green LED indicates when there is output from the converter. This gives reassurance to the installation enginer and speeds fault finding.

Technical Data:
• Input voltage range: 17-32Vdc
• Output voltage: 13.6Vdc +15% -20% at extremes of temperature, load, input tolerance, etc.
• Intermittent output power: As stated, taken for a maximum of 2 minutes followed by 8 minutes rest.
• Transient voltage protection: Meets ISO7637-2 International standard for 24Vdc commercial vehicles
• Electrostatic voltage protection: Meets ISO10605, ISO14892, >8kV contact, 15kV discharge
• Output noise: <50mV pk-pk at continuous load. Meets CISPR25.
• Off load current (quiescent current): <15mA
• Power Conversion Efficiency: Typically: 90% for non-isolated units, 85% for isolated units
• Isolation: >400Vrms between input, output and case, on isolated products only
• Mean time between failures: >162 years (HRD4)
• Operating temperature: -25ºC to +30ºC to meet this specification table, +30ºC to +80ºC de rate linearly to 0A
• Storage temperature: -25°C to +100°C
• Operating humidity: 95% max., non-condensing
• Casework: Anodised aluminium, glass filled polycarbonate, dust water and impact resistance to IP533
• Connections: Four 6.3mm push-on flat blade connectors (5 way Phoenix connector including enable on/off terminal and mating half
• Output indicator: Green LED adjacent to output terminals
• Mounting Method: Click ‘n’ fit mounting clip, fitted separately using three hole fixture
• Safe area protection:
- Over current: Limited by current sensing circuit
- Over heat: Limited by temperature sensing circuit
- Transients: Protected by filters and rugged components
- Catastrophic failure: Protected by input and output fuses
• Approvals: 2004/108/EC The general EMC directive 2009/19/EC & Reg 10.04 The automotive directive 93/68/EEC The CE marking directive
• Designed to: Reg 10, EN50498, ISO 7637-2, ISO 11452-1, ISO 14892, EN12895, ISO TR10605, EN60945, EN55022, FCC15B.
• Markings: CE